Live Events

Modeling and Simulation of Faults in a Battery System

Overview

MathWorks engineers will demonstrate how to model and simulate faults in battery systems. We will showcase:

  1. How to inject faults in a battery model including additional resistance fault, internal short fault, and exothermic reactions.
  2. How to characterize the thermal runaway behavior of a battery cell by simulating an accelerating rate calorimetry (ARC) test.
  3. How the battery management system (BMS) responds under fault conditions.
  4. How to conduct a Failure Mode and Effects Analysis (FMEA) per industry safety standards while leveraging simulation results

Please allow approximately 45 minutes to attend the presentation and Q&A session. We will be recording this webinar, so if you can't make it for the live broadcast, register and we will send you a link to watch it on-demand.

Highlights

Attendees will learn how to:

  • Inject and simulate faults in a battery model using Simscape Battery
  • Characterize the thermal runaway behavior of a battery cell using Simscape Battery
  • Detect fault conditions using Stateflow
  • Conduct a Failure Mode and Effects Analysis (FMEA) of a battery management system (BMS) while leveraging simulation results using Simulink Fault Analyzer

About the Presenters

Danielle Chu is a product manager at MathWorks supporting the Simscape product family and specializing in power electronics and battery systems. Prior to joining MathWorks, Danielle was at John Deere for 7 years, involved in developing power electronics control systems.  Prior to employment at John Deere, she performed postdoctoral work at the Center for Advanced Power Systems (CAPS), Florida State University and received her PhD in electrical engineering from the University of South Carolina and her MS in electrical engineering from Mississippi State University.

Pat Canny is a product manager at MathWorks supporting the Simulink Verification and Validation product family. Pat has a technical background in helicopter flight control systems and jet engine control systems.

Product Focus

Modelling and Simulation of Faults in a Battery System

Registration closed

View on-demand webinars