Board-Specific Setup Information

Note

For setting up the boards, you do not need an Ethernet cable or an SD card.

XilinxZynq UltraScale++ MPSoC ZCU102 FPGA Development Board

1. Set up the Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit as shown in the figure below:

To setup the board:

1. Plug in the power cord. If using JTAG connect the FPGA board to the host computer using a JTAG cable. If using Ethernet connect the FPGA board to the host computer using an Ethernet cable.

2. Configure SW6 switch which is shown in the image below:

   

   Use the configuration table below to configure the switch settings:

   Boot Mode	Mode Pins [3:0]	SW6 Switch Position [3:0]
   JTAG	0, 0, 0, 0	on, on, on, on
   QSPI32	0, 0, 1, 0	on, on, off, on
   SD	1, 1, 1, 0	off, off, off, on

   The SW6 default position is QSPI32. For the SW6 DIP switch moving the switch towards the ON label is a 0.

3. To learn more about the ZCU102 hardware setup, please refer to Xilinx documentation

Xilinx Zynq -7000 ZC706 Evaluation Board

To set up the Xilinx^®Zynq^® -7000 ZC706 board:

1. Configure SW4 shown in the image below, and to use Digilent USB-TO-JTAG interface using the following configuration table:

   Configuration Source	SW4 switch 1	SW4 switch 2
   None	0	0
   Cable Connector J3	1	0
   Digilent USB-TO-JTAG Interface	0	1
   JTAG (flying lead)Header J62	1	1

2. Plug in the power cord and then connect the host computer to the FPGA board by using a JTAG cable as shown in the image below:

   

3. To learn more about the board configuration, see Xilinx ZC706 Evaluation Board User Guide.