After you have completed the steps described in Convert to Fixed Point, compare the simulation behavior of the fixed-point version of your model with the floating-point baseline you collected at the start of the workflow to determine if the conversion was successful.
|Create fixed-point converter object|
|Verification results after converting a system to fixed point|
|Object containing run result information|
|Results from comparing two simulation runs|
|Results from comparing two signals|
Final step in autoscaling workflow.
Describes a method for debugging a fixed-point model
Reconvert your design using a new default data type
Iteratively explore different proposal settings to find the best floating point to fixed-point conversion
Use the Simulation Data Inspector to view simulation results and compare runs to verify your fixed-point design.
Learn how to use referenced data dictionaries to store multiple sets of data types for a model. This example also shows how to change the data types by switching the referenced data dictionary.
Under certain conditions, the Fixed-Point Tool may propose a data type that is not compatible with the model.