Connect device object to instrument
A device object or an array of device objects.
Update the state of the object or the instrument.
connect(obj) connects the
device object specified by
obj to the instrument.
be an array of device objects.
the state of the object or the instrument.
the object is updated to reflect the state of the instrument. If
the instrument is updated to reflect the state of the object. In this
case, all property values defined by the object are sent to the instrument
on open. By default,
Create a device object for a Tektronix® TDS 210 oscilloscope that is connected to a National Instruments® GPIB board.
g = gpib('ni',0,2); d = icdevice('tektronix_tds210',g);
Connect to the instrument.
List the oscilloscope settings that can be configured.
props = set(d);
Get the current configuration of the oscilloscope.
values = get(d);
Disconnect from the instrument and clean up.
disconnect(d) delete([d g])
obj is successfully connected to the instrument,
Status property is configured to
obj is an array of device objects and one of
the objects cannot be connected to the instrument, the remaining objects
in the array will be connected and a warning is displayed.