Main Content

Variable Resistor

Linear variable resistor in electrical systems

  • Library:
  • Simscape / Foundation Library / Electrical / Electrical Elements

  • Variable Resistor block

Description

The Variable Resistor block models a linear variable resistor, described with the following equation:

V=I·R

where:

  • V is voltage.

  • I is current.

  • R is resistance, that is, the signal value at the control port.

Connections + and - are conserving electrical ports corresponding to the positive and negative terminals of the resistor, respectively. R is a physical signal input port that controls the resistance value. The current is positive if it flows from positive to negative, and the voltage across the resistor is equal to the difference between the voltage at the positive and the negative terminal, V(+) – V(–).

Variables

To set the priority and initial target values for the block variables prior to simulation, use the Variables tab in the block dialog box (or the Variables section in the block Property Inspector). For more information, see Set Priority and Initial Target for Block Variables.

Ports

Input

expand all

Input physical signal that specifies the resistance value.

Conserving

expand all

Electrical conserving port associated with the resistor positive terminal.

Electrical conserving port associated with the resistor negative terminal.

Parameters

expand all

The minimum resistance value. If the input signal falls below this level (for example, turns negative), this minimum resistance value is used. The parameter value must be nonnegative.

Extended Capabilities

C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.

Introduced in R2007a