This example shows keyboard control of the TurtleBot® through the use of the
ExampleHelperTurtleBotCommunicator class. The instructions describe how to set up the object and how to start the keyboard control. Instructions on how to use keyboard control are displayed when the function is launched. To change parameters of the function, edit the
exampleHelperTurtleBotKeyboardControl function or the
ExampleHelperTurtleBotKeyInput class. For an introduction to using the TurtleBot with MATLAB®, see the getting started examples (Get Started with a Real TurtleBot or Get Started with Gazebo and a Simulated TurtleBot)
This example gives an overview of working with a TurtleBot using its native ROS interface. The Robotics System Toolbox™ Support Package for TurtleBot®-Based Robots provides a more streamlined interface to TurtleBot. It allows you to:
Acquire sensor data and send control commands without explicitly calling ROS commands
Communicate transparently with a simulated robot in Gazebo or with a physical TurtleBot
To install the support package, open Add-Ons > Get Hardware Support Packages on the MATLAB Home tab and select "TurtleBot-Based Robots". Alternatively, use the
Make sure you have a TurtleBot running either in simulation through Gazebo® or on real hardware. Refer to Get Started with Gazebo and a Simulated TurtleBot or Get Started with a Real TurtleBot for the startup procedure. If you are using simulation,
Gazebo TurtleBot World is good for exploring.
Initialize ROS. Connect to the TurtleBot by replacing
ipaddress with the IP address of the TurtleBot
ipaddress = '192.168.203.129'; rosinit(ipaddress)
Initializing global node /matlab_global_node_40274 with NodeURI http://192.168.203.1:55960/
If you are working with real TurtleBot hardware, make sure that you start the Kinect® camera. The command is:
roslaunch turtlebot_bringup 3dsensor.launch
Run this in a terminal on the TurtleBot.
Subscribe to the odometry and laser scan topics and make sure that you can receive messages on these topics
handles.odomSub = rossubscriber('/odom', 'BufferSize', 25); receive(handles.odomSub,3); handles.laserSub = rossubscriber('/scan', 'BufferSize', 5); receive(handles.laserSub,3);
Create a publisher for controlling the robot velocity
handles.velPub = rospublisher('/mobile_base/commands/velocity');
exampleHelperTurtleBotKeyboardControl function, which allows you to control the TurtleBot with the keyboard. Mark the inserted code example as code (highlight and press 'Alt+Enter') to actually execute the function.
Following are samples of the Command Window, the world plot, and the Gazebo world after some keyboard teleoperation by the user:
If you move the TurtleBot too quickly, the obstacle plotting can become messy because of relative inaccuracies in the odometry topic at high speeds. Here is an example of a messy world plot:
A sample plot of a real TurtleBot moving around an office space is shown:
Once you have exited the function by pressing
q, clear the publishers and subscribers on the host.
rosshutdown once you are done working with the ROS network. Shut down the global node and disconnect from the TurtleBot.
Shutting down global node /matlab_global_node_40274 with NodeURI http://192.168.203.1:55960/
Refer to the next example: Obstacle Avoidance Using TurtleBot