This example shows how to apply Simulink® Design Optimization™ to optimize the autopilot gains of an airframe to control its fin deflection. The model uses blocks from Aerospace Blockset™.
The autopilot controller consists of an inner pitch loop and outer vertical acceleration loop. Both controllers are integral only controllers. The gains of both the controllers are tuned to satisfy a 2 second rise-time step response characteristic.
nlairframe_demo model using the command below and run the simulation. The simulation produces an unoptimized vertical acceleration of the airframe and the initial data for optimization.
az Response Scope block to view the unoptimized vertical acceleration az of the airframe.
q Response Scope block to view the unoptimized rotation rate q of the airframe.
Model block to view the details of the subsystem. It includes an Atmosphere model and Aerodynamics and Equations of Motion model.
Desired az Response block to view constraints on the vertical acceleration of the airframe. These constraints are used to simultaneously tune the gains of the two integral controllers. The first segment of the upper bound constraint represents an overshoot. Note that this is a soft constraint and can be violated.
You can launch Response Optimization Tool using the Apps menu in the Simulink toolstrip, or the
sdotool command in MATLAB. You can launch a pre-configured optimization task in Response Optimization Tool by first opening the model and by double-clicking on the orange block at the bottom of the model. From the Response Optimization Tool, press the Plot Model Response button to simulate the model and show how well the initial design satisfies the design requirements.
We start the optimization by pressing the Optimize button from the Response Optimization Tool. The plots are updated to indicate that the design requirements are now satisfied.
The darker curve shows the final optimized response of the airframe.
% Close the model bdclose('nlairframe_demo')