Main Content

Installation Setup and Configuration

Install hardware support, update firmware, configure hardware connection

  • The Hardware Setup screen provides step-by-step instructions to install and configure Simulink® Support Package for Raspberry Pi™ Hardware. For more information on the installation process, see Install Simulink Support Package for Raspberry Pi.

  • Learn how to establish communication between host computer and your Raspberry Pi hardware.

Functions

raspberrypiGet host name, user name, password, and build directory

Setup Hardware

Install Support for Raspberry Pi Hardware

Install support for Raspberry Pi hardware.

Enable Passwordless Sudo on Raspberry Pi Hardware

Run Simulink models on Raspberry Pi without providing a password.

Setup Virtual CAN Interface

Setup virtual CAN interface before configuring CAN Transmit and CAN Receive blocks.

Configure Network Settings

Configure Network Settings of Raspberry Pi Hardware

Configure the network settings of your Raspberry Pi hardware.

Get IP Address of Raspberry Pi Hardware

You can use any of these methods to know the IP address of your Raspberry Pi hardware.

Access Internet When Raspberry Pi Is Directly Connected to Computer Using Ethernet

When Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.

Access and Configure Linux Operating System

Open Command-Line Session with Raspberry Pi Hardware

Open a serial command-line session with Raspberry Pi hardware.

Access Linux on Raspberry Pi Using Computer Peripherals

Set up Raspberry Pi hardware as a Linux® desktop or terminal.

Run Linux Shell Commands on Raspberry Pi Hardware

This example shows you how to run Linux® shell commands on your Raspberry Pi™ hardware.

Extend Linux Partition on SD Card

Extend Linux partition on the SD card for Raspbian Linux image.

Configure Parameters on Configuration Parameters Dialog Box

Model Configuration Simulink Support Package for Raspberry Pi Hardware

This section describes about the model configuration parameters.

Additional Capabilities with Simulink Coder and Embedded Coder

Include additional capabilities for code generation.

Configure Simulink Online

Connect to Raspberry Pi Hardware Board in Simulink Online

Configure, connect to, and control Raspberry Pi hardware in Simulink Online™.

Security Considerations for Raspberry Pi in Simulink Online

Take steps to secure your Raspberry Pi in Simulink Online.