Create free-running task
The Idle Task block, and the subsystem connected to it, specify one or more functions to execute as background tasks. The tasks executed through the Idle Task block are of the lowest priority, lower than that of the base rate task.
This block is not supported on targets running an operating system or RTOS.
The block output comprises a set of vectors—the task numbers vector and the preemption flag or flags vector. A preemption-flag vector must be the same length as the number of tasks vector unless the preemption flag vector has only one element. The value of the preemption flag determines whether a given interrupt (and task) is preemptable. Preemption overrides prioritization. A lower-priority nonpreemptable task can preempt a higher-priority preemptable task.
When the preemption flag vector has one element, that element value applies to the functions in the downstream subsystem as defined by the task numbers in the task number vector. If the preemption flag vector has the same number of elements as the task number vector, each task defined in the task number vector has a preemption status defined by the value of the corresponding element in the preemption flag vector.
Identifies the created
tasks by number. Enter as many tasks as you need by entering a vector
of integers. The default values are
[1,2] to indicate
that the downstream subsystem has two functions.
The values you enter determine the execution order of the functions in the downstream subsystem, while the number of values you enter corresponds to the number of functions in the downstream subsystem.
Enter a vector containing the same number of elements as the number of functions in the downstream subsystem. This vector can contain up to 16 elements, and the values must be from 0 to 15 inclusive.
The value of the first element in the vector determines the order in which the first function in the subsystem is executed, the value of the second element determines the order in which the second function in the subsystem is executed, and so on.
For example, entering [2,3,1] in this field indicates that there are three functions to be executed, and that the third function is executed first, the first function is executed second, and the second function is executed third. After the functions are executed, the Idle Task block cycles back and repeats the execution of the functions in the same order.
Higher-priority interrupts can preempt interrupts that have lower priority. To allow you to control preemption, use the preemption flags to specify whether an interrupt can be preempted.
that the interrupt can be preempted. Entering
the interrupt cannot be preempted. When Task numbers contains
more than one task, you can assign different preemption flags to each
task by entering a vector of flag values, corresponding to the order
of the tasks in Task numbers. If Task
numbers contains more than one task, and you enter only
one flag value here, that status applies to the tasks.
In the default settings
[0 1], the task with priority
in Task numbers is not preemptable, and the priority
task can be preempted.
When you select this option, Simulink software adds an input port to the Idle Task block. This port is used in simulation only. Connect one or more simulated interrupt sources to the simulation input.
Select this check box to test asynchronous interrupt processing behavior in Simulink software.