Main Content

Setup and Configuration

Install the hardware support for Xilinx® Zynq® Platform

The embedded target for Xilinx Zynq Platform enables you to:

  • Build a Simulink® model that loads and runs an executable on the ARM® Cortex®-A processor embedded in the Xilinx Zynq Platform.

  • Use the capabilities and features described in Supported Features for Xilinx Zynq Platform.

To get this embedded target, perform the steps described in Install Support for Xilinx Zynq Platform.

Functions

zynqDisplay most recent IP address, user name, and password

Apps

Run on Hardware BoardBuild, deploy, and run models on connected hardware boards (Since R2019b)

Topics

Troubleshooting

Troubleshooting Xilinx Zynq Platform and Development Computer Connection

To check if the Xilinx Zynq platform is properly configured, repeat the steps in TFTP/WFTPD Configuration Guide.

Configure Network Interface Card (NIC) on Development Computer

Configure a Network Interface Card (NIC) on development computer to connect to hardware board.

Get IP Address of Xilinx Zynq Platform

You can get the IP address of the Xilinx Zynq platform from the MATLAB® Command Window or using the Linux® command line.

Command Line Session with Xilinx Zynq Platform

Open a serial command-line session with Xilinx Zynq platform.

Sending PING Request to Xilinx Zynq Platform

Process to PING an Xilinx Zynq platform connected to your development computer.