When you open the HDL Coder™ HDL Workflow Advisor, you get the message that the HDL Coder Support Package for Xilinx® Zynq® Platform is not installed.
The HDL Coder Support Package for Xilinx Zynq Platform is required for FPGA targeting using HDL Workflow Advisor. Install this support package.
When you target the ARM® processor with the workflow in the HDL Workflow Advisor, you get a message at Step 1.1 that says "Embedded Coder® Support Package for Xilinx Zynq Platform is not installed. You must have that support package installed to run the "Generate Software Interface Model" task.
To use external mode, or fully deploy your design to the board, install the Embedded Coder Support Package for Xilinx Zynq Platform. Otherwise, you can ignore this message.
The Video Capture (software interface) block icon shows a red error message saying it cannot find the Embedded Coder Support Package for Xilinx Zynq Platform.
Double-click the block for more information. Click the link to go to the Add-Ons menu for installing the support package.
There is also an install link in the warning message in the Diagnostic Viewer.
To use this block, install Embedded Coder and the Embedded Coder Support Package for Xilinx Zynq Platform.
You selected (or had selected for you) multiple support packages or products during installation, and received the error message "There was an error installing Product_Name".
Retry the install with only one support package selected at a time. You may need
to delete old files from your
SupportPackages install folder.
Alternatively, start MATLAB® using Run as Administrator.