configure closed-loop control system

2 views (last 30 days)
Im new to this sooo... help!
My simulink model shows the results of a tank system (2 tanks), the water levels h1 and h2. What do I have to do to make a closed-loop system out if. the bigger the h1 level the bigger the R2 flow, the same goes for the h2 and R3?

Accepted Answer

Arkadiy Turevskiy
Arkadiy Turevskiy on 7 Jul 2014
It appears R1, R2, and R3 are the vales you want to control. So these or a subset of these should be controlled by a controller. For example, take a look at a simpler, but similar example where there is an inflow valve we use to control the water level.
  1 Comment
Amir
Amir on 9 Jul 2014
how can I make a figure according to that picture above? I just want the fluid levels to be shown in the figure in real-time, the scope values to be shown for both tanks, something like in this picture below.

Sign in to comment.

More Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!