Can't get GPS readings from Pixhawk 4 mini in "Reading GPS Data from PX4 Autopilot" Example
3 views (last 30 days)
Show older comments
Samuel Razumovskiy on 16 Sep 2021
Commented: farah bouzidi on 6 Jul 2022
I followed all the steps in the example and am struggling to figure out what is going wrong. I select my Hardware Board as PX4 Pixhawk 4 and my CMake config is px4_fmu-v5_multicopter (I tried with px4_fmu-v5_default as well). My output during a run is in the screenshot I added and I attached my rc.txt. Also, the drone and GPS work with the normal PX4 firmware. Thanks!
farah bouzidi on 6 Jul 2022
hello , i have the same problem , statue 1 but the others 0. i didn't change anything on the rc.txt
how can i solve it?
Ankur Bose on 11 Nov 2021
I suggest you use the default Pixhawk rcS as the startup script to do that. We support this in R2021b. Follow the documentation Load and Start Modules on PX4 Autopilot after Boot-Up to know more about this. Launch hardware setup in R2021b and set the startup script as mentioned in Selecting Startup Script for PX4 Autopilot
Find more on PX4 Autopilots in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!Start Hunting!