Xilinx system generator HW co-simulation the Drive DAC input and ADC output are missing

Hello,
I would like to perform HW co-simulation on my ZC706 Eval board using system generator, I found a video on youtube that performs HW co-simulation using kintex-7 DSP kit. here is the link to the video: https://www.youtube.com/watch?v=oJGHcl6Vk4g
In the video, the In and Out Gateway interfaces from the system generator blockset in Simulink have an option called Drive DAC input and Drive ADC output, respectively.The screenshot is attached. In this way the Simulink model can be verified on FPGA platform and RF transceiver easily using system generator.
Why do my system generator In and Out - Gateways interfaces have not this option?
Is it possible to perform HW co-simulation for ZC706 evaluation board in combination with ADRV9002 RF transciever(mixed signal system) using system generator?
Thank you in advance!
Kind Regards
Arash

1 Comment

Arash - That video was originally recorded in 2012 using a Kintex-7 programmed through Xilinx ISE. I do not believe that the same programming methodology holds for Zynq under Vivado. Happy to discuss co-simulation options with you off-line. Please reach out to me through adi-expert@mathworks.com.
Regards,
-noam

Sign in to comment.

Answers (1)

This behavior is expected and is due to differences between older and newer System Generator workflows.
  • The video you’re following is based on an older ISE/Kintex-7 flow, and those Gateway block options were available there.
  • In newer Vivado/Zynq-based flows, the “Drive DAC input” and “Drive ADC output” options have been removed or are no longer exposed the same way.
What this means:
  • There’s no misconfiguration on your side
  • The feature is simply not supported in current workflows
What to do instead:
  • Use the current HW co-simulation flow (e.g., JTAG-based cosim)
  • Interface ADC/DAC through board-specific IP or RF transceiver frameworks, not Gateway block options
Bottom line is, you’re comparing a legacy flow with a modern one—so the missing options are expected, and you’ll need to follow the updated co-simulation methodology for Zynq/Vivado.

Categories

Find more on Signal Processing in Help Center and File Exchange

Products

Release

R2021a

Asked:

on 6 Mar 2022

Answered:

on 4 Jun 2026

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!