How to use model predictive control and quadprog() in MicroAutobox III
Show older comments
I use Matlab2018b to build MPC function in Simulink, but there's an error Function 'quadprog' not supported for code generation and quadprog() can not work in AutoboxIII. Does it work that I update Matlab to 2022a? If not, what might be the possible solutions?
Answers (2)
Pratheek
on 31 Mar 2023
0 votes
Hi Zekun Yang,
Quadprog does support Code Generation but there are some constraints and limitations for that, go through the following to make sure you are not violating any of them: Quadratic programming - MATLAB quadprog (mathworks.com).
Here is an example for useing code generation for quadprog: Generate Code for quadprog - MATLAB & Simulink (mathworks.com)
Hope this resolves your issue!
1 Comment
Zekun Yang
on 1 Apr 2023
Emmanouil Tzorakoleftherakis
on 31 Mar 2023
0 votes
Hi,
You can use quadprog for simulation and code generation as a solver in Model Predictive Control Toolbox as of R2021b release (see here). So if you upgrade you should be all set. By the way, Model Predictive Control Toolbox also has other built-in QP solvers you can try as you see fit (see here).
Hope this helps
Categories
Find more on Deep Learning Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!