Mux to Bus error message

33 views (last 30 days)
Matthew
Matthew on 20 May 2015
Commented: Mujtaba Syed on 13 Oct 2021
I'm getting a strange error when trying to run one of our models in simulink: I'm being told 'The block diagram 'Filename' uses bus signals. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'. To prevent modeling errors:'
Why am I getting an error message for something I've deliberately turned off? Due to the way the model interfaces with our software it has to have a mux creating a bus otherwise it won't work so I can't replace the muxes with buses.
  1 Comment
Kevin Quigley
Kevin Quigley on 16 May 2017
You accepted the answer, but it's unclear if using the suggested setting solved your problem or it prevented you from using your model as implied in your question.
What was the outcome of setting this to 'error'? Did you have to rework the model?

Sign in to comment.

Accepted Answer

Vinod Sudheesh
Vinod Sudheesh on 27 May 2015
Hi Matthew,
To avoid this error please navigate to
Model Configuration Parameters (Ctrl+E) >> Diagnostics >> Connectivity >> Mux blocks used to create bus signals:
and set the value to "error".
Please note that this diagnostic needs to be set to "error" whenever there is a bus signal in the Simulink model so as to ensure that there will not be any problems with block connections while compiling the model.
Hope this helps!
Vinod
  9 Comments

Sign in to comment.

More Answers (1)

Gagandip Singh Khanduja
Gagandip Singh Khanduja on 19 Jul 2018
Thank you for useful information

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!