Plot problem after DC offset
1 view (last 30 days)
Show older comments
Hi all,
I am plotting an EMG signal which is loaded from a text file. The original signal is shown in the top plot of the attached image. When performing DC offset removal from the raw signal I am getting two lines, one in green and one in blue (second figure). Why is this? How can I keep the green signal only? Below is the code used for removing the DC offset:
EMG_DCoffset_removed = detrend(raw_EMG);
figure(1);
plot(EMG_DCoffset_removed);
0 Comments
Answers (1)
Star Strider
on 4 Nov 2015
I cannot duplicate your results with this simulation or with a constant offset:
raw_EMG = rand(1, 1000) + (1:1000)/100;
EMG_DCoffset_removed = detrend(raw_EMG);
figure(1);
plot(EMG_DCoffset_removed);
hold on
plot(raw_EMG)
What did you do to make MATLAB angry at you?
0 Comments
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Spectral Measurements in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!