How can I control servo motors via Simulink and arduino MEGA 2560 hardware with normal mode and real time sync

1 view (last 30 days)
Josephine Gotz
Josephine Gotz on 5 Jun 2016
I'm trying to control servo motors via a matlab function on simulink through and Arduino MEGA 2560 board (image below of the simulink model). I know the matlab function works as when I simply 'run' the function on normal mode it works however when I attempt to deploy it to hardware I get the error: ## Failed to generate all binary outputs. I can control the motors using External mode(though not with this model) but not in Normal mode, are there certain configuration settings I should be using or is this not at all possible with the Arduino board?
I would also like to know if it is possible to work with arduino hardware using the real time sync, I have tried to do this however it seems that arduino can only use the code generation ert.tlc which does not work with the real time sync.
I am using MATLAB 2016a and the most recent version of the Arduino Target hardware add-on. The matlab code takes the xyz position of an object and using inverse kinematics turns that into theta 1-4 for a robot arm, which then sends the the theta value to the motors via the Arduino MEGA2560. Thanks for your help, Josie.

Answers (0)

Communities

More Answers in the  Power Electronics Control

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!