How to speed up a Simulink simulation of slow mechanics requiring a fast clock?
Show older comments
What are the best methods to speed up a simulation that uses a 5Mhz clock but needs to simulate 2 sec of run-time?
I am running a brushless DC motor in a phase lock loop (DPLL) simulation and am concerened with estimating jitter. My actual system uses a 50MHz clock in a FPGA. I am simulating with a 5MHz clock because I want a resolution of at least 0.2us on jitter estimates.
I am using a combination of S-functions and sub-sytems. I am using a boolean pulse generator at 5Mhz as the clock. My motor model is continuous time. I only run S-functions if the clock transitions low to high. I only run the phase detector on the rising edge of the reference or feedback as sampled with the rising edge of the boolean clock. The compensation, a digital filter, is an S-block that is only run if the phase detector state changes. The effective sample rate is 360Hz.
Because it is a mechanical system I need to simulate about 2 seconds of time to gather lock and seettle.
Thanks,
Brian
1 Comment
Brian Tremaine
on 16 Jul 2019
Answers (1)
Bharath Venkataraman
on 15 Jul 2019
0 votes
There are a wide variety of things you can do. The first thing to try is to run the model in Accelerator or Rapid Accelerator mode. You can also try to change the model to simulate frames rather than scalar values.
1 Comment
Brian Tremaine
on 16 Jul 2019
Categories
Find more on Title in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!