If Action Block that create a stairstep signal in simulink
1 view (last 30 days)
Show older comments
Alberto Mora
on 1 Jun 2020
Answered: Fangjun Jiang
on 1 Jun 2020
Hello,
I have two questions:
- I use a If Block to "cut" the signal and not perform some operations (not depicted below). Is it the right approach to use a "If Block" for interupt the signal and don't allow to perform some tasks by the model?
- However I notice that after the "If Block" the signal became discrete (see the plot below, where you can see a stairstep plot), even if before the "If Block" the signal was continous (see the plot below, where you can see a continous plot). How to convert again the discrete signal into a continous?
0 Comments
Accepted Answer
Fangjun Jiang
on 1 Jun 2020
The "sample time" of the Constant block might have been set as "1" second.
0 Comments
More Answers (0)
See Also
Categories
Find more on Sources in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!