MATLAB Answers

K
0

The legend show different sign

Asked by K
on 29 Nov 2012
Hello, I try to plot my graph and also do the legend. However, the legend show a different type of symbol. The example of my code is as below. However when I run my simulation, both current and voltage have symbol ro.
figure(1) hold on
for ii=1:N voltage... resistance.. .. xx(ii) = ii; plot(ii,voltage, 'ro'); end
plot(xx,current, 'rx'); legend('voltage','current',2);

  0 Comments

Sign in to comment.

Tags

Products

1 Answer

Answer by Arthur
on 29 Nov 2012
 Accepted Answer

This is because you are plotting data in a loop, and will make N plots with symbol 'ro'. Therefore, also the first N entries in the legend will have 'ro'.
You can fix this by collecting all voltage data in one array, and create a single plot. If that is not possible due to the structure of the data, you can set the handleVisibility to 'off' for all voltage plots with ii > 1. This means they will be skipped in the legend.

  2 Comments

K
on 29 Nov 2012
How can I set the handleVisibility to off?
K
on 29 Nov 2012
Thanks guys for your reply. I use this code plot(ii,voltage, 'ro', ''HandleVisibility', 'off');

Sign in to comment.