Community Profile

photo

Sai Vaddi


Active since 2018

Statistics

  • Thankful Level 1

View badges

Content Feed

View by

Question


i have 10 buses and i have to select only one bus at a time based on the bus number. i have used switch case to select bus based on the bus number and finally connected 10 buses to merge block.Dspace is not supporting merge block.Is there any solut
i have 10 buses(having 15 signals) and i have to select only one bus at a time based on the bus number. i have used switch case ...

3 years ago | 0 answers | 0

0

answers

Question


i have a CAN message, whose signal values has to be varied.How should i vary the signal values.Could anyone explain the procedure in simulink.Thanks in advance.
i have a CAN message, whose signal values has to be varied.How should i vary the signal values.Could anyone explain the procedur...

3 years ago | 0 answers | 0

0

answers

Question


i am using rti CANMM library in simulink.can i simulate the model having rti CANMM blocks. Is any Supporting packages required?
i am using rti CANMM library in simulink.can i simulate the model having rti CANMM blocks. Is any Supporting packages required?

3 years ago | 0 answers | 0

0

answers

Question


How to create a matrix[15*1], in which i need to change the value of particular element during simulation.
How to create a matrix[15*1], in which i need to change the value of particular element during simulation.And the rest of the va...

3 years ago | 2 answers | 0

2

answers

Question


i want to generate a pwm of variable duty cycle
i want to generate a pwm of variable duty cycle like first 200 ms duty cycle should be 35%,for next 250 ms duty cycle should be ...

3 years ago | 1 answer | 0

1

answer

Question


I need to iterate the for-loop subsystem 3 times. For each iteration, the output result will then be then be the input for the next iteration and the result for each iteration should be displayed.Thanks in advance.
for example; thetaL=10; //intial value for(i=0;i<3;i++) { thetaL0=thetaL; thetaL1=(42.8/38.4)*w; thetaL=thetaL+thetaL1; }...

3 years ago | 1 answer | 0

1

answer