Simulate Model in Connected IO Mode
You can use Simulink®
Connected IO mode to run a real-time simulation. This procedure
uses the model
sldrtex_model. To open this model, in the MATLAB
Command Window, type:
It assumes that you have loaded that model.
In the Simulink Editor, double-click the Scope block.
The Simulink software opens a Scope window with an empty graph.
On the Desktop Real-Time tab, select Mode > Connected IO for the simulation mode.
Open the block parameters of the Real-Time Sync block in your Simulink Desktop Real-Time™ model.
To prevent missed ticks, set values for the Sample Time and Maximum Missed Ticks block parameters.
To begin simulation, on the Desktop Real-Time tab, click Run in Real-Time.
The Simulink software runs the simulation and plots the signal data in the Scope window.
To stop the simulation before it ends, on the Simulation tab, click Stop.
The real-time application stops running, and the Scope window stops displaying the output signals.