Run Model on Target Hardware
Simulink® deploys code and logs signals on an SD card. These signals are saved as MAT-files on the target hardware.
To deploy the code on the target hardware, go to Hardware tab in the model window, and click Build Deploy & Start.
The lower left corner of the model window displays status while Simulink prepares, downloads, and runs the model on the target hardware. Wait for the logging to stop.
After the Stop time (specified in the Modeling tab of the
Simulink model window) elapses, the logging of signal stops. However, the model
continues to run. For example, if the Stop time parameter
is specified as
10.0 seconds, the logging stops after 10.0
seconds. However, the model continues to run for an indefinite time. If the
Stop time parameter is specified as
Inf, the logging continues until the SD card memory is
full, or you remove the SD card from the target hardware.