Can start an External Mode with debugger on Simulink

Hello.

Recently in my workplace we adquire two new XDS110 Debug Probe to have a total of three (One adquired a few years ago).

We are using this devices to monitoring a board designed to control another two high power boards via Simulink and serial communication. The issue is that the new debugger are not able to connect to the board that is using a F280048 microcontroller, while the previous debugger it is capable to connect.

As you can see in this picture, with the first debuuger is running without issues and I able to control it.

But with any of the new debuggers I am getting this error. And I am not changing anything (cables, program to load, setting on the serial ports, board to use) just changing the debugger.

Also, all of them have the same firmware version.

I dont know that if there is some setting or change that I have to do to the new debugger to able to use them properly.

I hope you can help me.

Thank you.

[Ganesh Thambhahalli Satyen]

Hi Carlos,

Are you facing this issue with the new debugger on CCS as well?