Matlab D-statcom example control error
2 views (last 30 days)
Show older comments
Matlab has below D-statcom control example.
In situation of voltage regulation, I set up the input voltage has +/-0.2pu changes, but I found out the voltage regulation output is not as good as expected. The result has obvious steady state error. You can refer to the attached picture for more information. (The example use +/-0.06 voltage change, it works fine, but if the change bigger, it will not work well)
I found that the D-Statcom base power is 3Mvar, maybe I need to increase D-Statcom base rating, but I can not figure out how to do it.
Can anyone give me some suggestions?
Thanks!
0 Comments
Answers (1)
Devi Satya Cheerla
on 12 Jun 2015
Moved: Sabin
on 18 Dec 2022
try changing the capacitance value in the d- statcom
0 Comments
See Also
Categories
Find more on Power Converters in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!