How to connect the ANSYS Workbench to Matlab to perform the optimization loop in Matlab ??? Please...

Please I have performed structural analysis using ANSYS Workbench to obtain the stresses and strains, so I have to define those response parameters to the Matlab to perform the optimization study on Matlab. Please answer my question as I have limited time to do this job.

[Ali Makvandi]

Hi

how can i transfer equations from MATLAB to designed model in ANSYS? and make relation between model and equations?

[George Ghimire]

Hi Ali can you guide me in optimizing parameter from matlab. i am working on similar field. Thanks

Answer 1

[Sarah Palfreyman]

See ANSYS for the MATLAB AAS Toolbox interface.

http://www.ansys-blog.com/how-to-make-matlab-apps-for-ansys/

[Nawfal Hsaine]

Thank you very much Sarah, it is helpful answer. I'll try to use this procedure to connect my own program. Thanks again for your help

Nawfal Hsaine

Answer 2

[Sindhuja Parimalarangan]

You can refer to the following links for books and videos on MATLAB-ANSYS interaction :

http://www.mathworks.com/support/books/book99102.html?category=7&language=1&view=category

http://www.mathworks.com/support/books/book48100.html?category=7&language=1&view=category

http://www.mathworks.com/matlabcentral/fileexchange/?term=ansys

[Nawfal Hsaine]

Thank you Sindhuja for your answer and I am sorry to answer lately. The last link seams helpful to me but I am wondering is this working with workbench or just for APDL as I am obtained my results on Ansys workbench. I appreciate your answer if you can recognize this link is working on APDL or Workbench: http://uk.mathworks.com/matlabcentral/fileexchange/53032-interactive-link-between-matlab-and-ansys

Thanks Nawfal Hsaine

[Umut Senol]

Dear Nawfal Hsaine , have you finish this task ? If you did, could you please share your codes or road map with us. I am dealing with this sort of problem right now.

Answer 3

[Stelios Fanourakis]

Hello

@Nawfal. Can you please describe me the technique you used to obtain stress strain in ANSYS?

Maybe provide me some link.

Thanks