Selection data from Discrete Root Mean Square simulink
1 view (last 30 days)
Show older comments
Emiliano Ascenzi
on 15 May 2020
Commented: Emiliano Ascenzi
on 18 May 2020
I have calculated the Discrete Root Mean Square of a signal in a sampling interval equal to the stopping time of the simulation. I used this block.
I applyed the to workspace block, selecting array as save format, to see how the results are (attached). I need to select only the number different from zero, I tried to use the block Selector but I didn't reach the desired output
Someone can tell me how to use Selector properly on a Discrete Root Mean Square block?
Thanks in advance
0 Comments
Accepted Answer
Jyotsna Talluri
on 18 May 2020
As you specified that your Discrete RMS Value block generates output [0;1.0977] ,make sure you set the Input port size of the selector block as 2 and as you want to get only second element which is not zero ,set the Index vector in the Index Option as [2].Set the Number of input dimensions as 1 and Index mode as one-based.
5 Comments
Jyotsna Talluri
on 18 May 2020
Here,the issue is not with the selector block.As you set the sample time of discrete RMS Block and stop time of simulation to a certain same value,the values are computed at two time instants (t=0,t=sampletime) during simulation .To Workspace block logs the output at the each of these instants due to which you are obtaining two values.As you want only last final value as output, set the 'Limit data points to last' parameter in the 'To Workspace' block to 1 inodrder to log only final output of simlation.
More Answers (0)
See Also
Categories
Find more on Sources in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!