Run Matlab FUNCTION at the end of Simulink simulation
28 views (last 30 days)
Show older comments
Alberto Mora
on 30 May 2020
Commented: Alberto Mora
on 5 Jun 2020
Hello,
in a simulink simulation I compute some signals.
At the end of the simulation, when the system reach the steady-state condition, I want to use the final value of such signals to create a custom 3D plot. To do that I already built a Matlab FUNCTION block.
I don't want to run such Matlab FUNCTION block during the simulation because the computational time grows so much, and moreover I am interested only in the final value (steady-state).
How can I run such "Matlab FUNCTION block" only at the end of the simulation?
Thanks and best regards
2 Comments
Accepted Answer
Sai Sri Pathuri
on 30 May 2020
You may use StopFcn callback in your model. Refer the following link for Model callbacks. Expand Model Simulation Callback Parameters in the below documentation for StopFcn.
7 Comments
Sai Sri Pathuri
on 2 Jun 2020
Okay, In order to avoid overwriting and plot only last time step data, you may try this.
In constant block you used for FlagEndSim, use constant value as
[zeros(lengthOfOutput-1);1]
and Sample time as below. This is to retain previous sample rate after conversion by buffer
stepSize*lengthOfOutput
After the constant block, use buffer with output buffer size of 1.
With these changes, you can plot the results of only last simulation.
This is an example I tried at my end. I used a StopTime of 10 and a variable solver. For this, the output is of length 51 and step size is 0.2 (obtained from tout)
So, I have used the following settings
% Constant value
[zeros(50);1]
% SampleTime
0.2*51
More Answers (0)
See Also
Categories
Find more on Model Verification in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!