Configure Holding Registers
Configure holding registers to read data from the holding server register
Since R2025a
Model Configuration Pane: Hardware Implementation / Simulink or Embedded Coder Hardware Support Package / Hardware board settings / Target hardware resources / UART/USART
Description
Select the Configure Holding registers parameter to configure the starting address and the number of holding registers.
Dependencies
To
enable this parameter, set Mode to
server.
Settings
on |
offSelect this parameter to configure the starting address and the number of holding registers.
Holding Register Parameters
| Parameter | Description | Default Value |
|---|---|---|
Start address | Starting address of the holding register Dependencies: To enable this parameter, select Configure Holding registers. | 0 |
| Quantity | Number of holding registers Dependencies: To enable this parameter, select Configure Holding registers. | 1 |
Recommended Settings
No recommendation.
Programmatic Use
| No programmatic use is available. |
Version History
Introduced in R2025a
