Conversion of Simulink Model to previous version

I have my models saved in 2020b version

Requsting the community members to support me for 2015a version

Answer 1

[Jesús Zambrano]

Go to the Simulation Tab and do:

Then, select the release version:

[Siva Murugesan]

Hello Zembrano,

Thank you for the solution.

The issue is that, I don't have a 2020b version to export it to previous version.

It would be of great help if you can do that for me.

Thanks in advance :-)

[Jesús Zambrano]

Hey Siva, here you are.

Seems that exporting the RLC_Circuit model was OK, but the Noise_Filter model was partially converted. The error message says:

Block of type "dsp.LowpassFilter" uses functionality that is not available in Simulink R2015a and has been replaced with an empty subsystem.

Block of type "SpectrumAnalyzer" uses functionality that is not available in Simulink R2015a and has been replaced with an empty subsystem.

That's all I can do for you at this point. Otherwise, get R2020b! :-)

I suggets you contact the designer of those models and check the setting used for those two blocks, so you can run the model in R15a.

Best,

Jesús

[Siva Murugesan]

Hello Zambrano,

That's a bit to worry but thanks to you.

I will be able to take this further.

Thank you once again.

Regards,

Siva