How do i open a com port in Matlab
Show older comments
My program is always showing the ports as closed
Serial Port Object : Serial-COM1 Communication Settings Port: COM1 BaudRate: 9600 Terminator: 'LF' Communication State Status: closed RecordStatus: off Read/Write State TransferStatus: idle BytesAvailable: 0 ValuesReceived: 0 ValuesSent: 0 Serial Port Object : Serial-COM2 Communication Settings Port: COM2 BaudRate: 9600 Terminator: 'LF' Communication State Status: closed RecordStatus: off Read/Write State TransferStatus: idle BytesAvailable: 0 ValuesReceived: 0 ValuesSent: 0
Accepted Answer
Katheryn Restrepo
on 31 May 2020
0 votes
fopen () entre parentesis pones como tienes la variable del serial
ejemplo
se = serial ('COM5')
fopen (se)
More Answers (0)
Categories
Find more on Data Acquisition Toolbox Supported Hardware in Help Center and File Exchange
Products
on 24 Nov 2014
on 31 May 2020
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
