Failed:Code generation information file does not exist.
Show older comments
Hello,
I am trying to build and upload some different models to TMS320F28379D in Simulink. However I get the same following error. Similar errors are asked on previous messages but there is no answer to explain them.
What is the reason of this error and how can i solve it?
Answers (1)
Apeksha Bagrecha
on 21 Sep 2022
Edited: Stefanie Schwarz
on 22 Nov 2023
2 votes
The message "Code generation information file does not exist" itself is expected behavior and means that the code was generated because it had not been generated prior to the build.
1 Comment
Gokhan Solak
on 3 Mar 2023
Sometimes it is ok, when it says "Action: code generated and compiled", but in this case it says "Action: failed", and the simulation will not run.
In a similar question, someone recommended removing spaces from the file path, or shortening the file path (moving the file).
Categories
Find more on Simulink Coder in Help Center and File Exchange
on 15 Sep 2022
on 22 Nov 2023
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
