how to assign angle
5 views (last 30 days)
Show older comments
Offroad Jeep
on 14 May 2016
Commented: Image Analyst
on 14 May 2016
Hi to all I am fine and hoping for the same. I want to take cos(theta) of the angle but for a = 1 and b = 1 angle should be 0 and for a = 1 and b = -1 it should be 180. The result should be in matrix form again. File attached.
Regards
0 Comments
Accepted Answer
Image Analyst
on 14 May 2016
You do not multiply a and b by the cosine. You multiply a and b by pi and put it inside the cosine, cos(), OR multiply by 180 and put inside cosd(). See if that hint can help you. meshgrid() may also help.
2 Comments
More Answers (0)
See Also
Categories
Find more on Trigonometry in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!