Simulink multiport switch problem

8 views (last 30 days)
Kit
Kit on 22 Jun 2016
I would like to use 3 pid controllers with a switch to control the system (switch from PID controller to PID controller3 at t=5s and then to PID controller6 at t=10s). But the switch seems not working properly.
This is the PID controller output (the first PID controller output)
This is the PID controller3 output (the second PID controller output)
This is the PID controller6 output (the third PID controller output)
I suppose to have the following controller output
But I got this controller output which is the same as the PID controller output (the first PID controller)
Here is the .zip file of this Simulink model.
p.s. I tried to adjust the parameters in the PID controllers and the switch is working properly. So, I think the switch is affected by the port1,2,3 inputs which are the controller outputs??? Where's the problem?

Answers (2)

goerk
goerk on 22 Jun 2016
Try to typecast your switching signal (from signal builder) to int32.
  3 Comments
goerk
goerk on 23 Jun 2016
There is a block called: Data Type Conversion
Kit
Kit on 23 Jun 2016
same result. Anyway, thanks a lot.

Sign in to comment.


Kit
Kit on 23 Jun 2016
Solved. I think the switch is working.
  1 Comment
Thorsten Tatarek
Thorsten Tatarek on 8 Feb 2017
How do you solved it? i have a similar problem with the multiport switch. I use a rectangular pulse generator signal on port 1 and a sin wave signal on port 2. i wanna switch between them. When i have the sin wave connected, but use the rectangular switch port with a constant, the signal is kind of diagonal instead of a rectangular up and down.

Sign in to comment.

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!