How can I view an internal signal of a reference model in Accelerator mode?
8 views (last 30 days)
Show older comments
MathWorks Support Team
on 16 Mar 2018
Answered: MathWorks Support Team
on 16 Mar 2018
I would like to use a Scope to view an internal signal of a reference model. However, if I put a Scope inside the reference model and run the simulation in Accelerator mode, the Scope is not updated and remains empty.
Accepted Answer
MathWorks Support Team
on 16 Mar 2018
Here are two ways to accomplish this:
1) Using "outport" blocks in the model reference and scoping the relevant signals from the top-level model.
2) Using the Simulation Data inspector (either from the top-level model or from the model reference) and logging the desired signals.
0 Comments
More Answers (0)
See Also
Categories
Find more on View and Analyze Simulation Results in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!