MATLAB Answers

How can I fix propagation speed error using Simscape Power System?

55 views (last 30 days)
Euan McLean
Euan McLean on 30 Mar 2018
Commented: kalim ullah on 5 Mar 2021
I’m running 2017b, using a model I think was created in 2015x. When I try to run the model, I receive the following error:
“A propagation speed of...has been found for Mode 1 Block 10. Propagation speed must be < 300000 km/s.”
Analysis of the model forms part of a university coursework, and I can’t see anything obvious to change to allow it to run correctly. Thanks.
kalim ullah
kalim ullah on 5 Mar 2021
I am facing the same problem, and not even able to adjust it by adjusting LC parameters of PI line. What I should do? please suggest

Sign in to comment.

Answers (1)

Prasanth Sunkara
Prasanth Sunkara on 2 Apr 2018
Hello Euan,
It seems to be an "improper" configuration of the Simscape TL blocks.
The error message you see from the model is due to propagation speeds larger than 300000 km/s, which is causing the propagation time to be smaller than the sample time. Please refer to the following links to understand more about the parameters and block equations for Distributed Parameter Line and PI Section Line:
- Prasanth

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!