MATLAB Answers

0

F28069 Simulink Time Step

Asked by Euan Andrew on 18 May 2018 at 13:11

Hi all,

I'm trying to produce a simple simulink model to read data from four SPI slave ADCs. The f28069m SPI peripheral has only on "Chip Select" line so I have taken TI's advice and used GPIO pins as "Chip Select" lines.

When I run this on the external target, it executes MUCH slower than I would expect. The time step for the program would appear to be 100ms, as shown in the attached oscilloscope capture. How can a change this time step as it is set to 100e-6 in the simulation settings?

Thanks.

  0 Comments

Sign in to comment.

0 Answers

Discover what MATLAB® can do for your career.

Opportunities for recent engineering grads.

Apply Today