MATLAB Answers


Reset a sine wave in Simulink

Asked by Mitchel
on 14 Jun 2018
Latest activity Commented on by Fangjun Jiang on 16 Jun 2018
Hi all,
So I'm trying to reset a sine wave its phase in Simulink. The idea is:
- When I enable the block, a cosine wave starts at zero.
- When the block disables, the output is zero.
- When the block enables again, the phase of the cosine is reset and starts at zero again.
If I use the enabled block, the output gets zero, but when enabling again, the cosine just continues its phase, so if the enabling is not in phase with the cosine, it does not start at 0 again.
This is what I am able to get:
But when the phase of the enabling block pulse changes, the sine does not reset its phase:
Someone has an idea how to do this?


Sign in to comment.

1 Answer

Answer by Fangjun Jiang on 16 Jun 2018

Use the "Fcn" block which you can specify "sin(u)" as the function. Use an "Integrator" block with the input as constant value of 1 or other value. Enable the "reset" (select level) of the "Integrator" block, your enable/disable signal will be the "reset" input. Feed the output of "Integrator" block to the input of "Fcn" block.

  1 Comment

Re post. Similar answer was deleted by Birdman.

Sign in to comment.