Data acquistion toolbox problem..

Hello. I have a question.

I want to measure the electrical signal through Simulink Data Acquistion Toolbox(ver 3.1).

MY hardware is National Instruments SCXI-1125( terminal block is SCXI-1313a high voltage attenutor) whose input range is from

-300 V to 300 V.

However, when I use analog input block and set the 'Device' as 'SCXI-1125' , my computer is

stopped !.

Is it possible to use Data Acquistion Toolbox to measure high voltage input signal??

[Walter Roberson]

Do you mean that your entire computer hangs? Or do you mean that MATLAB crashes? Or does MATLAB produce an error message?

[Shankar Subramanian]

Computer stopped is too generic. Can you elaborate more? Also, were you able to successfully acquire using the device from within MATLAB. A little bit more information will help us guide you in the right direction.

Thanks.