How to generate a signal with time delay?

Hello guys,

I'm creating a model in Simulink in which I have a sinusoidal input and I need to generate an output signal like the following:

100 if the signal is positive

zero when the value of the signal is whithin the range [-0.1,0.1]. This output value must be kept during 1 second regarless the value of the input.

-100 if the signal is negative.

I'm not sure if it's better to use delay blocks or a matlab function.

Any ideas??

Thanks.

[Basavalingappa Mudhol]

Let me know if its this behaviour you expected i can give solution for this

[Juan Nunez]

Hello Basavalingappa

Thank you for your answer. Yes it's exactly what I require.

Answer 1

[Basavalingappa Mudhol]

Basically There are three parts in my model

1(in picture) this logics checks your base condition like if the input lies in which range >0.1 or <0.1 based on this either 100 or -100 is set

And the tricky part. if its in the range of 0.1 to -0.1 hold it for 1 sec. this is done by part 2 and 3(in Picture).

Here in part 2 is for the timer of 1 second. once your input is wihin range it triggers a counter until 1 sec.

and part 3( in picture). this is to latch he output to 0 for 1 second. after 1 second the counter is reset and it rechecks for the input.

I am bad at explaining may be this gives you a basic idea.

Please comment if you have questions. and vote and accept the answer if it solves your question.

I just tried to do a quick modelling . So this can be optimised even further if its just for simulation or you need to for code generation

thanks. :) Nice problem

[Juan Nunez]

Hello Basavalingappa

I'm sorry for the late reply. I built the model using your suggestion and it worked without any problem. Again thank you for your answer.

[madhan ravi]

@Juan if it worked make sure to accept the answer