How to access to open source codes toolbox of camera calibration?
Show older comments
I wanted to know how to access to the camera calibration open source codes?
Thank you for helping me;
Accepted Answer
Walter Roberson
on 11 Dec 2018
0 votes
2 Comments
Mahdi Noroozi
on 11 Dec 2018
Walter Roberson
on 11 Dec 2018
Edited: Walter Roberson
on 11 Dec 2018
when you read the documentation of how camera calibration works it says it is based upon a particular paper as implemented by a third party toolbox that it gives link to. That link in turn tells you that the code is included in the open source OpenCv toolbox. Which is what MATLAB calls .
You asked for a link to the open source implementation that MATLAB uses and that is the link: it calls a routine from OpenCv.
More Answers (0)
Categories
Find more on MATLAB Support Package for USB Webcams in Help Center and File Exchange
on 11 Dec 2018
on 11 Dec 2018
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
