Data is missing in scope and in output tables when simulating a wind farm

For a simulation I received wind farm data of one year in 10 minute steps (>50000 data values). However, only a fraction of these are taken into account in the calculations and are shown incompletely in the scope. What can I do to show all data in the scope or to save all data into a table in the workspace?

Answer 1

[Arvind Sathyanarayanan]

Nils,

You'll have to check the Logging in the scope properties. Ensure that you're not limiting the data points. To save to workspace check the log data to workspace box

[Nils van Ohlen]

Hello,

I checked that and I think that's all right.

The image above shows how the data looks like after I ploted it. But in the scope the most data are missing. This can be seen in the next picture:

[Arvind Sathyanarayanan]

Have you tried using a fixed step solver with a time step that is 5 to 10 times greater than your the rate at which your look-up table data was generated?

[Nils van Ohlen]

Thank you! That was the problem!