Saving Simulink environment and data from run?

I have a Simulink model that takes a couple hours to run. When the run is completed I'd like to be able to save the environment and scope data so I can recall the setup at a later time as if I had just done a re-run. Is this possible? Or do I need to export all scope data into Matlab then later run a custom matlab program to display results?

Thanks,

Brian

Answer 1

[Vimal Rathod]

You can use Simulation Operating Point to save and restore the states and data.

Refer to the following link:

https://www.mathworks.com/help/simulink/ug/saving-and-restoring-simulation-operating-point.html

Hope this helps.

[Brian Tremaine]

Thank-you!!! This is more than I hoped for, excellent!