MATLAB Answers

Using triggered subsystem with either - need a reset but how?

5 views (last 30 days)
s0ter48
s0ter48 on 29 Oct 2019
Commented: s0ter48 on 18 Nov 2019
Hey guys,
I need to use a triggered subystem to detect flanks (pos and neg) and calculate the time difference between these and then pass the value on to calculate the speed which will go into a PI controller and herefore i need also the the values (in my case it will be 0 - when no more flanks are detected) when the system is not triggered anymore.
But my problem is that the triggered subsystem starts when the flanks starts and hold the last value when no flanks are coming anymore.
I need the 0 at the beginning and the 0 at the end because with this i would pass on a wrong value to the controller.
2019-10-28_17-01-32.png
I build an example so u can understand what I mean.
Thanks in advance. =)

  0 Comments

Sign in to comment.

Answers (2)

s0ter48
s0ter48 on 1 Nov 2019
Hmm... nobody can help me with this?

  0 Comments

Sign in to comment.


Ganesh Regoti
Ganesh Regoti on 6 Nov 2019
Hi,
There is no such feature of resetting the block states in triggered subsystem. It is also stated in the documentation here.
Instead you can use Enabled Subsystem block if it suits your model as it has the resetting of states option. You can refer the following link
Hope this helps!

  1 Comment

s0ter48
s0ter48 on 18 Nov 2019
Hey,
sorry for the late response.
I dont think it will work with an enabled subsystem.
I buid an example to show u.
At the end there are no flanks anymore so I want a 0 at this point but how can i realise this?

Sign in to comment.

Sign in to answer this question.