MATLAB Answers

SIL simulation timeout (60 seconds)

8 views (last 30 days)
Adrian Stancu
Adrian Stancu on 17 Jan 2020
I am trying to perform a SIL simulation by using the SIL block which interfaces the autocode generated with ert.tlc , C language.
During simulation I receive the following timeout error:
"An error occurred while running the simulation and the simulation was terminated
Caused by:
The timeout of 60 seconds for receiving data from the rtiostream interface has been exceeded. There might be multiple reasons for this failure.
You should:
(a) Check that the target hardware configuration is correct, for example, check that the byte ordering is correct.
(b) Confirm that the target is running.
(c) Consider the possibility of application run-time failures (e.g. divide by zero exceptions, incorrect custom code integration, etc.).
Note (c): To identify possible reasons for the run-time failure, consider using SIL, which supports signal handlers and debugging.
If you cannot find a solution, consider using the method setTimeoutRecvSecs of rtw.connectivity.RtIOStreamHostCommunicator to increase the timeout value."
I know that the code is running very slow, so I expect to exceed 60 seconds. Is there any way to set more than 60 seconds for contection timeout in order to avoid this error?
I am using Matlab 2017a 64 bit.
Thanks in advance.
Adrian

  0 Comments

Sign in to comment.

Answers (0)

Sign in to answer this question.