IBIS, SPICE simulation using matlab simulink and mixed signal toolbox

I am designing a Data acquisition system with a Texas instruments ADC, Inamps and a ST micro electronics micro controller. I am getting spice models for my inamps, differential amplifiers etc. so that I could do SPICE simulation using any spice softwares.

I wish to see the output of my ADC if I am providing an input signal with my simulated amplifiers and filters. I am getting an IBIS model of the ADC.

I am new to these IBIS models. I am not sure what it is used for. When I read some introductory papers, I understood it is also a behavior model. Is it possible to use the mixed signal tool box to import spice netlist of my amplifiers and the IBIS model file of my ADC (downloaded) and give a signal as input and get the results for FFT/transient analysis?

Answer 1

[Peter LaFlamme]

Not sure if you are still looking for a solution to this but MW has introduced two new toolboxes in the past few years that will allow you to simulate your application. Take a look at Parallel Link Designer, part of Signal Integrity Toolbox.