Why do I encounter a "Firmware upload failed" error when using the Hardware Setup dialog for the UAV Toolbox Support Package for PX4 Autopilots?
3 views (last 30 days)
Show older comments
MathWorks Support Team
on 9 Mar 2021
Answered: MathWorks Support Team
on 9 Mar 2021
I am going through the steps in the Hardware setup for the UAV Toolbox Support Package for PX4 Autopilots, and I am receiving the following firmware upload error after successfully building the firmware.
Accepted Answer
MathWorks Support Team
on 9 Mar 2021
This error message is caused by a permissions issue, as seen in the Command Window of the second image. This can be resolved by closing MATLAB and opening it in Administrator mode.
0 Comments
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!