Adding IP3 and 1dB Compression Points to Amps breaks RF Toolbox Simulation

I'm workin on a simple RF amplifier simulation in RF Toolbox and am running into issues when I try to add IP3 informaiton and 1dB Compression Point information. After changing these parameters, an error populates that says "The total number of carriers in the non-linear circuit is too large. Reduce the number of tones or harmonics". However, when I try to adjust the tones and harmonics I'm unable to reduce them to a point where I don't get this error regardless of the values that I put. Does anyone know what I can update in my simulation to be able to run this circuit with the correct nonlinearity parameters?