How to connect simulink block and simpowersystem block

I want to connect these two blocks. How can I?

Answer 1

[Azzi Abdelmalek]

Look at this Simulink-PS Converter

[Pramit Biswas]

i tried but it's not working here unfortunately. :(

[Azzi Abdelmalek]

Connect your ramp signal to Simulink-PS Converter. Are the two blocks connected?

After that you should maybe connect the output of your S-PS block to a controled current source or controlled voltage source, then connect the output to your rlc circuit.

Answer 2

[Azzi Abdelmalek]

In SympowerSystem/Electrical Sources choose a controlled Curent Source or Controlled Voltage Source (Depends on what you need). Connect the Output of your rampe To its first input, Connect the Ground to its second input. Connect its Output to Your Serie RLC Branche

Answer 3

[zoheir tir]

Dear All,

Please find attached a good idea about the connection between the Simulink block with the simpowersystem block.

I used the boost converter as ex.

Regards

Zoheir